1. Attach the two front legs to the seat. Slot the ends of the legs into the housings on the seat. Push the
pins in the tops of the legs in and slide into the housings (1), ensure the ends of the bars on the seat
are inserted into the housings on the legs (2). Ensure the pins are protruding through the holes in the
housings after fitting.(3)
2. Slot the two back legs into the rear housing on the seat. Push the pins on the legs inwards and fully
insert into the housing. Ensure the pins are protruding through the holes in the housings after fitting.
3. Slot the feet onto the ends of the legs. Ensure the feet are slotted onto the correct legs. The base of
the feet are marked with two letters, see diagram for the correct fitting.
4. Slot the end of the footrest into the housing on the underside of the seat. Push the leg rest in until it
locks into the housing.
5. Attach the tray support to the front of the seat. Slot the tabs on the back of the support into slots in
the seat (1). Rotate the support down until the front locks onto the seat (2).
6. Slot the hooks on the ends of the tray into the slots in the sides of the seat (1). Ensure the feet on the
ends of the tray are resting on the buttons on the seat under the tray (2). Push the tray down until it
locks onto the tray support (3).
7. Slot the buckes on the ends of the harness straps through the slots in the seat pad. Place the seat
pad in the seat and slot the buckles through the slots in the seat.
8. Slot the tabs on the waist straps into the buckle (1). To adjust the harness, slide the straps through the
adjusters to the required lengths (2).
9. To open the harness, push the locking tabs inwards (1) and slide the two waist strap tabs out of the
buckle (2).
