background image

9

Chapter VIII:  Fault Analysis and Troubleshooting

Fault phenomenon 

Analysis of causes 

Fault resolution

After connecting the 
power supply, turn on 
the switch, but this 
product cannot work.

1. The power plug is not plugged in 
properly
2. The outlet is in poor contact
3. The internal cable of the main unit 
is off or the circuit board is damaged.

1. Plug the power plug back in again
2. Replace the power socket and try 
again
3. Please send the product to the 
nearest maintenance shop for 
inspection

When this product is 
used initially, the motor 
smells terrible. 

This is not an abnormal occurrence

If the product still emits this odor after 
repeated use, please send it to the 
nearest maintenance shop for 
inspection.

This machine stops 
during the application. 

1. The voltage is too low
2. Excessive or hard ingredients
3. The continuous working time is too 
long

1. Check if the voltage is too low
2. Disconnect the power and remove 
the excess ingredients (Sugar cane 
cannot be juiced. Hard skin / hard core 
fruits and vegetables should be first 
removed the hard skin / hard core 
before juiced)
3. It is a normal phenomenon, and the 
motor will resume operation after a 
break

Noise when operating

1. The auger and fine strainer are not 
fully installed, resulting in unsteady 
operation;
2. The start motor in the machine body 
breaks down.
3. Too noisy when some ingredients 
are juiced.

1. Fully install the auger and fine 
strainer.
2. Please send it to the nearest 
maintenance shop for inspection.

It is difficult to unscrew 
the juicing body cover 
after juicing

1. There is an oil stain on the surface 
of the juicing body cover;
2. The ingredients in the juice net are 
not juiced completely;

1. Clean the surface of the juicing 
body cover;
2.  Continue  to  turn  on  the  machine,
and  squeeze  all  the  ingredients,  or 
long-press  the  “Reverse” key  for 
several  seconds  to  rotate  the 
ingredients out of the juice strainer.

Note:
The above are analysis and resolution of common faults. As for other faults, please contact the Customer 

Service Department of this company or come to an appointed maintenance point of this company to change. 

Be sure not to take apart or repair by yourself.

Facebook: #Mama's Choice US

Message: #Mama's Choice US

Email: mamaschoice_service@outlook.com

Summary of Contents for MMC2001











Reviews: