MAMMOTH MODULAR DISPLAY
MAMMOTH 8FT DISPLAY (BACKLIT)
PRODUCT CODE: MAM8X8LBF
SET UP INSTRUCTIONS
Page 1 of 2
a.
Slide the Split Connectors into the grooves
of the frame and tighten
b.
Attach other extrusion onto the Split Connector.
c.
Tighten screws with included
5mm allen
wrench.
a.
Insert the Corner Connector
locks into the ends of the frame.
a.
Line up the holes on feet with holes
on the bottom horizontal frame piece.
b.
Insert screws and washers into
hole to secure feet to frame.
b.
Insert End Lock into top and bot-
tom grooves of frame. Tighten screws
with
torx key
to secure connection.
1. Attach Split Connectors to Top, Bottom, & Side Extrusions:
2. Attach Corner Connectors:
4. Make Support Strut:
5. Attach Support Strut To Frame:
3. Install Feet:
b.
Then attach side extrusion onto
the Corner Connector. Tighten screws
with included
5mm allen wrench.
a.
Remove screws from
Center Connector.
a.
End Lock is already attached to
opposite ends of Support Strut.
b.
Insert Center Con-
nector and align holes
with holes on extrusion.
c.
Repeat to connect
other extrusion to make
one long piece.
1
1
2
2
2
2
1
1
5
5
4
3
3
