Mamo Cuce A3 Digit, Owner'S Manual

26 

RE V. 2.0/07-13

3 

SAFETY INSTRUCTIONS

3.1 

SAFETY CRITERIAS

In the design and construction of this machine were adopted criteria and suitable measures to meet the essential safety requirements of 
the Machinery Directive and the Low Voltage and EMC Directives. (see declaration of conformity).
The careful analysis of the risk analysis carried out by the manufacturer has eliminated most of the risks connected with the use of the 
machine, which is provided for reasonably foreseeable.
Full documentation of the measures taken for safety is contained in the Technical File of the machine, deposited with the manufacturer.
The manufacturer recommends to strictly follow the instructions, procedures and warnings contained in this manual and the applicable 
safety legislation in the workplace, even if you use protective devices provided, either integrated in the machine that individual.

3.2 PROTECTIONS

It is strictly forbidden to tamper protections and safety devices

3.2.1    r

esidual

 r

isks

During some procedures of intervention on the machine from time to time reported in this manual, there are residual risks for the operator. 
These risks can be eliminated by carefully following the rules set out in this guide and by adopting the personal protective equipment listed.
The power cable should be located and protected so that it can not be walked on.
Maintenance operations can be performed only by service technicians authorized by the manufacturer.

3.3 

QUALIFICATION OF PERSONNEL

See the relevant section the definition of qualified personnel.
At different stages of the life cycle personnel must possess appropriate professional experience in operations to which is assigned by the 
manager. As a reminder, see the following table.

Technical phases of the life of the machine 

Qualified Personnel

Transport 

Qualified Personnel

Installation 

Qualified Personnel

Use 

Qualified Personnel

Maintenance 

Qualified Personnel

Extraordinary maintenance 

Technicians appointed by Mamo

Demolition 

Qualified Personnel

3.4 NOISE

Data on the noise produced by a machine identical to that shown in this manual, as measured according to the instructions of the 
“Machinery Directive” (98/37/EEC), Annex I point 1.7.4. letter F
The level of acoustic pressure measured weighted sound level meter with a Class 1 operator in place in front of the machine operating at 
its maximum speed is less than 70 dB (A).

Ch A P t ER 3: S A fE t y iNSt RuC t iONS