RE V. 2.0/07-13
CuCE A3 Digit 31
6 USE
6.1
OPERATOR QUALIFICATION
The use of the machine must be performed by qualified personnel. The machine is intended for use by a single user at a time, which must
have received adequate information and training.
6.2
WORKPLACE AND MACHINE ELEMENTS
In the starting phase the operator occupies the front part with respect to the machine. This position could be changed according to the
processes in place.
6.3
WORKING INSTRUCTIONS
The power cord of the electrical energy must be adequately protected and should not cause hindrance to the operator.
6.3.1 P
reliminary
ProCedures
To avoid that the guides compromise paper movement inside the machine, 1 mm should be left between the right /left edges of
the paper and the guides borders
P
aPer
width
adjustment
Proceed as follows to adjust the width of the sheets to be used:
•
loosen knob (1), adjust the guide position using the scale
applied on the machine surface and fasten the knob;
•
place the sheets to the left guide edge;
•
adjust the position of the right guide turning knob
P
aPer
height
adjustment
Proceed as follows to adjust the length of the sheets to be used:
•
place the sheets on the intake slot;
•
adjust its position turning knob up to the correct line up with
the paper size indications on the machine scale;
ENG
Ch A P t ER 6: uSE
Summary of Contents for Cuce A3 Digit
