Commissioning and operation
32
Setting the illumination (external illumination)
Select here whether illumination of the tachometer and the connected bus instruments are to be connected
internally or externally.
EXTERNAL:
The illumination is switched on and off through an input of the 14-pin plug.
Dimming of the illumination is thus not possible.
INTERNAL:
The illumination is regulated in the normal operating mode by pressing and
holding the push-button key in 8 steps.
Selection of the displays (Screen on / off)
Select here which measured values are to be displayed in the normal operating mode.
YES:
Here all measured values, with their ISO symbol, are displayed. By selecting
NO", the measured value can be removed from the normal operating mode.
If the measured value is to be displayed again, select YES" when the ISO
symbol of the measured value is displayed
NO:
No change in the setting are made.
Activation of the simulation mode (simulator mode)
Select here whether the simulation mode is to be switched on.
YES:
The simulation mode is switched on. The display now generates random va
lues for all measuring channels and displays these. The measured values are
also transmitted to the bus instruments.
NO:
The simulation mode is switched off.
Please note that the simulation mode still remains after switching off and switching on again, if it has not
been switched off by selecting NO.
Setting of the number of exhaust gas temperature measured values (Charge Boost Amount)
Select here whether one or two measured values are to be displayed for the exhaust gas temperature be
fore the turbine.
1:
One exhaust gas temperature measured value.
2:
Two exhaust gas temperature measured values. (V-engines)
Ending the settings (exit setup)
Select here whether the settings are to be exited.
YES
The settings are exited, the display restarts in the normal operating mode.
NO
The settings are restarted.
