Commissioning and operation
89
Description of the operating elements:
General:
After switching on the supply voltage for the Mini-Marex system and the entire system of the mobile navig
ating console, all correctly functioning command masters are in the state 'lamp test' (all LEDs and buzzers
on). The lamp test is terminated automatically after a short time and the standard takeover procedure be
gins. At each navigating console, pressing the Command button once requests the command. Pressing the
Command button again takes over the command.
Command push-button:
Pressing the button
requests the command takeover for the mobile navigating console. This state is
indicated by the two Command LEDs flashing and the buzzer sounding.
D
The two LEDs and the buzzer will be flashing respectively bleeping fast if com
mand transfer is possible. The command may be transferred by pressing the
push-button
once again.
D
The two LEDs flash and the buzzer beeps slowly when no command takeover
is possible. An error cause can be that the command master levers are not
located in the same range of the active navigating console.
Steady lighting of the two command LEDs signal the transfer of command. In this mode of operation the
buzzer is turned off. The hand-held remote control is now active and can give commands.
Special function “Warming Up"
The “Warming Up" function can be used to set a specified speed without shifting the gearbox. This function
is required to warm up the engines.
To enable the “Warming Up" function, press the
button and simultaneously place the lever in For
wards or Reverse. The button can then be released. To switch off, return the lever to Neutral. The
button must not be pressed here.
If the function “Warming Up" is active, the command LED will be flashing.
.
Warm-up function can be switched on and off independently for each side. The command LEDs are as
signed to the corresponding levers.
slowly bleeping
Fast bleeping l
