38
1.3.2
Brake Adjustment
The brake is factory set, however, after extensive use the brake may need to be adjusted.
For technical support, please call
1-800-361-2260
for more information
Loosen pivot nut
Adjust solenoid gap
Remove solenoid cover
Tighten pivot nut
Check brake adjustment
Pull the lever to adjust the gap between
the plunger and solenoid body.
Gap must be between 1/4''and 3/8''.
Manually push the plunger onto
the solenoid body, and verify
that the brake drum rotates
easily by hand.
Solenoid Cover
Brake
Drum
Pivot Nut
Re-install solenoid cover
Recheck the gap
measurement.
Lever
Plunger
1
2
4
3
6
5
Summary of Contents for BOARD 070M
