Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
11
Square
pipe
Wheel
guard
Wheel
guard
pipe
Bracket
Spring
Width
Rod
Dia
board
housing
Width
Assy
4.4.2.
WHEEL GUARD
1.
Fix the Wheel guard bracket at the rear side of
cabinet using Bolt & Spring washer.
2.
Fix the Square pipe with the bracket using
Allen
screw & Spring washer.
3.
Fix the Wheel guard with pipe using Allen
button
head screw, Nut, Spring & Plain washer.
4.
Fix the Wheel guard & pipe assy with
Square pipe using Nut, Spring & Plain
washer. Ensure Wheel guard is without
any tilt.
5.
Verify & ensure the limit switch functions of
Wheel guard by opening & closing the guard.
Fig. 5
6.
Hook one end of the Wheel guard spring with Square pipe and the other
end with the Cabinet. Ensure the Wheel guard assembly is
perpendicular to cabinet.
4.4.3.
WIDTH MEASURING ROD
1.
Remove the Bracket back sheet from Bracket.
2.
Insert the Safety cover into Wheel guard bracket & then fix Width rod
with bracket using Allen screw & Spring washer by matching the Arrow
stickers. Ensure the Width rod is perpendicular to cabinet.
3.
Route the Outer dia wire through the Dia board housing and then fix it to
the Outer dia board. Connect the housing assembly with the Width rod.
4.
Remove Width board back cover. Connect Width wire to width board.
5.
Bring the Width assembly cable through the bracket and connect Male
end of Wire from Width measuring rod to female end provided below the
Bracket at the rear side of cabinet.
6.
Fix the Safety cover with the Bracket using WH-PH screw. Ensure Width
cable is covered by Safety cover without touching any moving parts.
7.
Fix the Bracket back sheet with Bracket using WH-PH screw.
8.
Insert the Width rod at the sliding block in the Wheel guard properly.
4.4.4.
MCD
1.
Insert the Threaded shaft into Tyre seating cone and fix the assembly
with Rotor Main shaft firmly using Allen screw & Spring washer (1 No.)
each by matching the Arrow stickers pasted in both the Tyre seating
cone & Main shaft.
2.
Ensure the Rotor shaft is free from Runout. Else correct it.
Fig. 6
Fix the Cone holding stems with left side of cabinet and locate the Wheel seating cones
with the respective Stem as shown below:
Finally verify & ensure the cabinet is free from tilt again.
4.5.
INITIAL OPERATION
1.
Provide power supply and switch ON the equipment.
2.
Press
key twice to run the Empty shaft and ensure the „0‟ value is displayed
in both windows.
3.
Mount a wheel (Refer Chapter 7.3) & balance the same (refer Chapter 7.4). Add
a known weight on
both sides (Inn
er and Outer). Check for its value and position
are displayed correctly. If not, perform calibration (refer Chapter 9.1) and again
conduct balancing operation.
TYRE SEATING
CONE WITH STUD
ALLEN KEY
(10m m )
WHEEL CLAMPING
SHAFT - THEAD SIDE
ALLEN
SCREW
