Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
23
Following screen will be displayed, once the system enters into
WHEEL RUN
screen:
Fig. 19
Select
RIM PARAMETERS
option and press
key.
If Auto Distance feature is enabled, user can also move the Distance / Diameter
measuring rod to enter into RIM PARAMETERS screen automatically from
POSITION TRACKING screen
The current System settings available/set will be displayed in the Status bar
The
Job number
window shows the count of current of job number & it gets
automatically incremented whenever a wheel is balanced. If the Job count
reaches maximum count of „99999‟, a message will be prompted & the system
will reset the count to „00001‟ automatically
7.4.1.
RIM PARAMETERS
While setting Rim parameters using Navigation keys, ensure the
Distance/Diameter & Width measuring rods are at Home position
In case of
Static balancing
mode enabled in SETTINGS screen, only
Diameter
window will be accessible for setting the dimensions
Rim parameters can also be set by rotating the wheel itself instead of
using keys, if Auto Distance/Width/Diameter feature is not enabled
If Rim distance is >
4.8” in Alu-2 & Alu-3, “
Distance input is not in valid
limits
” will be displayed in POSITION TRACKING screen. Measure &
enter Rim distance correctly
DYNAMIC BALANCING MODE
STATIC BALANCING MODE
Fig. 20
