23
Fig. 15 Lighting and rear light assemblies and their location.
Before transporting, the machine should be cleaned from the soil and the operation of
the lights checked. After lifting the machine, check the clearance under the lowest
working elements, which should be at least 25 cm. The permissible transport speed of the
tractor with the machine is 15 km/h. It should be reduced to 10 km/h on roads with poorer
surfaces and 5 km/h on dirt roads. Extreme caution should be exercised when passing and
overtaking other vehicles, avoiding obstacles and crossing large irregularities in fields and
durt roads.
4.6.
Maintenance and lubrication
•
Each time the cultivator is finished working, the soil must be cleaned, followed by
an inspection of the parts and assemblies.
Otherwise, there may be a problem
with the folding of the machine if the shafts are clogged with soil and there is
an additional load!
•
Re-tighten all bolts after the first 4 hours of operation and periodically check the
tightness.
Failure to do so will exacerbate backlash and result in damage to the
machine.
•
Lubricate the lubrication points on the hinge pins, shaft bearings, disc bearings and
spring systems every 25 operating hours during the service life of the machine.
•
When replacing worn components, use thread glue, original bolts and nuts.
•
Always ensure that screw connections are properly tightened.
NOTE! Periodic lubrication is a guarantee of the durability of the machine.
Rear light system
