www.mc-techgroup.com
Temperature controller 70304 | 1.02.00
5
3
SAFETY INSTRUCTIONS
Please take care of the following basic safety procedures when mounting, starting up or operating this
equipment:
Read this operating manual before starting up and use of the equipment. The information and warnings given in
this operating manual must be heeded.
Any work on electrical equipment is only to be carried out by trained specialists as per the regulations currently in
force.
Attention must be paid to the requirements of VDE 0100 (IEC 364) when setting high-power electrical units with
nominal voltages of up to 1000 V, together with the associated standards and stipulations.
Check the details on the type plate to ensure that the equipment is connected to the correct mains voltage.
Protection against touching dangerously high electrical voltages:
Before opening the equipment, it must be switched off and hold no voltages. This also applies to any external
control circuits that are connected.
The device is only to be used within the permitted range of temperatures and pressures.
Check that the location is weather-protected. It should not be subject to either direct rain or moisture.
The temperature controllers 70304 and 70304.2 must not be used in hazardous areas.
Installation, maintenance, monitoring and any repairs may only be done by authorized personnel with respect to
the relevant stipulations.
4
WARRANTY
If the equipment fails, please contact
M&C
directly or else go through your
M&C
authorised dealer.
We offer a one year warranty as of the day of delivery as per our normal terms and conditions of sale, and assuming
technically correct operation of the unit. Consumables are hereby excluded. The terms of the warranty cover repair
at the factory at no cost or the replacement at no cost of the equipment free ex user location. Reshipments must
be send in a sufficient and proper protective packaging.
