MANDÍK CPV Installation, commissioning, and maintenance
IZU 02/2021
MANDÍK, a.s., www.mandik.cz
R
10
the carrier’s delivery note. Failure to follow this procedure may result in denial of any
claim involving damage during transport.
•
Units must be stored in dry, and clean covered premises, protected from rain and snow,
and in which the ambient temperature does not drop below +5 °C; they must also be
protected from physical damage, contamination and corrosion caused by persistent
exposure to condensed water vapour on the surface of the unit.
•
ATTENTION: If the equipment is suspended during transport, a safe distance must be
maintained from the load and never enter the area under a load. Keep the
acceleration and speed of lifting within safety limits. Never leave the equipment
suspended for longer than necessary!
Permitted handling:
1)
Preparation and handling using a pallet truck
Openings are provided in the frame of the units for handling. During use, pallet truck
forks must remain fully under the chamber.
2)
Preparation and handling using a forklift
Openings are provided in the frame of the chamber for handling. During use, the forklift
forks must remain fully under the chamber, see the illustration.
ATTENTION: The chamber is not evenly balanced in terms of weight. Handling
activities and lift heights must be adapted appropriately!
3)
Chambers are transported and handled on non-returnable pallets
During use, the forks on the forklift or pallet truck must remain fully under the pallet.
ATTENTION: The chamber is not evenly balanced in terms of weight. Handling
activities and lift heights must be adapted appropriately!
4)
Handling with the unit using steel tubing and straps
The tubing must be passed through the round openings in the corner of the frame over
the entire length, or width of the unit. The tubes must extend past the straps
a minimum of 100 mm. It is best to equip the ends of the tubes with clips to prevent the