4
NOTE: VMC1 does not distinguish between audio from a room being monitored and
audio from the tuner. If a room is to be monitored, it is recommended that the
tuner be turned off.
Set Volume Level at Master Station
To change the speaker volume at the Master Station:
1. Turn Radio ON to provide an audio source
2. Press MUS button to activate speaker at the Master Station
3. Press (plus) or Volume – (minus) buttons to adjust level
Setting Volume Levels at Room Stations:
To change the speaker volume at any Room Station:
1. Press the or Volume – buttons
to adjust level
Room station will emit a steady tone increasing or decreasing in level
depending on the button being pressed.
This tone eliminates the need to have
an audio source active at the Master
Station while setting the desired volume
level.
Your installer may disable this tone at
each room station, however doing so
will require an active audio source at
the Master Unit to set the volume levels. If this is disabled, follow the
steps under Setting the Volume Level at the Master Station to set the
volume levels at the Room Stations.
Privacy
Press PRIV
button to disable microphone
This prevents any audio from transmitting. The Station continues to
receive calls, however.
Point-To-Point and Whole House pages.
Page any Station where Privacy is active by following the
Room-To-Room or Whole House Paging instructions.
Answer Calls in Privacy Mode:
1. Press and release PRIV button
to speak. Station now functions
normally.
2. Press and release the PRIV button again
to end conversation.
Station remains in Privacy mode until disabled.
3. Press the PRIV button
to disable Privacy Mode.
Quick Start Guide: Music & Audio
VOLUME
+ (higher)
__ (lower)
PLUS + & MINUS -
