background image

INSTRUCTIONS

521CFI

Cod. 521,53 - 10/06

Copyright © 2006 Manfrotto Bassano Italy

PRECAUTIONS
Water resistivity

We put a lot of attention on making the controller to be
as much water resistant as possible, while maintaining
its reasonable price.
However we cannot guarantee 100% water resistance
under all circumstances and you should avoid using the
controller under heavy environment conditions like rain
and over 95% humidity level.

High temperature

Avoid temperatures exc70°C – especially do
not leave the controller exposed for direct contact with
heavy sun shines, e.g. in the car parked in sunny place.

OPERATING SPECIFICATIONS

Operation temperature range 

0°C - +50°C

Storage temperature range 

-30°C - +80°C

Humidity rel. (non condensing) 

max. 95%

Power supply 

from camera (6V max.)

Power consumption 

25mW

DISCLAIMER

The information contained in this document is subject of
change without notice.
Manfrotto makes no warranty and shall not be liable for
any errors on information contained in this document.

OPERATION
Selecting zoom speed limit

Turn zoom speed limit knob from up to down to set
lower zoom speed limit.
Turn the knob in opposite direction to set higher
speed limit.

Variable mode zoom

Rotate the zoom knob right (or left, dependent on the
zoom direction) to zoom tele. The more angle the knob
is rotated the faster zoom speed is. Zoom speed is
limited to pre-set speed (see “Selecting zoom speed
limit”).
Rotate the knob left (or right, dependent on the zoom
direction) to zoom wide. The more angle the knob is
rotated the faster zoom speed is. Zoom speed is
limited to pre-set speed (see “Selecting zoom speed
limit”).

Customizing zoom direction

To change the zoom direction, move zoom direction
switch, found on the right side of the controller body,
to opposite position.

REC/STOP

Press the button once to start recording.
Press the button again to stop recording.

RET function

It used to play back last 3 seconds of footage, then
stop at the last recorded frame ready to record again.
Press the button to execute RET function.

Reviews: