With an existing Windows 7/Vista/XP installation
1. Power off the computer. Insert the SATA 6Gb/s PCI Express Card into
an available PCIe slot. Turn on the computer.
2. After bootup, Windows will display the Found New Hardware Wizard
and “PCI Device.”
3. Skip the driver installation.
4. Run the installer DrvSetup.exe on the driver CD (E:\ SATA6G_M9128)
to install the latest driver for 32-bit / 64-bit Windows.
InSTAllATIon vErIfICATIon
1. Right-click on My Computer and go to Properties. Left-click on the
Hardware tab, then click “Device Manager.”
2. Double-click on “SCSI and RAID Controllers.” If there is no yellow
exlamation point (!) or question mark (?) displayed in front of
“Marvell AHCI SATA Controller,” the driver is installed correctly.
SPECIfICATIonS
3
3
Standards and Certifications
• FCC, CE, SATA 2.6, PCI
Express 2.0
Port Specifications
• 2 SATA (internal) L-type
• Transfer rate: 6 Gbps
General
• Supports 2 independent SATA
channels
• 48-bit LBA for support of HDD
larger than 137 GB
• 2-pin header for LED connection
• Supports 1-lane 5 Gbps PCI
Express 2.0
• Hot-plug capability
• Independent link, transport and
data FIFO
• Independent command fetch,
scatter/gather and command
execution
• Supports native command
queuing (NCQ)
• 31 commands and scatter/
gather tables per port
System Requirements
• Windows XP/Vista/7/Server
2003/2008 (32- and 64-bit)
• Available PCI Express Card slot
• CD-ROM drive
Package Contents
• SATA 6Gb/s PCI Express Card
• User manual and driver CD
