115
Select “Enable” or “Disable” to enable or disable the firewall
function. Then click Apply; the following message will be displayed
on your Web browser:
Click Continue to go back to the previous setup menu or to
continue to other setup procedures; or click Apply to reboot the
router so the settings will take effect (wait about 40 seconds while
the router is rebooting).
3-3-1 Access Control
This function allows or denies computers with specific MAC
address from connecting to the network. It can also allow or deny
computers with specific IP addresses, protocols or ports.
Click Firewall on the left side of the Web management interface,
then click Access Control; the following message will be displayed
on your Web browser:
1
2
3
5
6
7
8
9
10
12
13
14
15
16
11
0
4
