1-14
INSTRUCTIONS FOR HANDLING A LOAD
A - CHOICE OF ATTACHMENTS
- Only attachments approved by MANITOU can be used on its lift trucks.
- Make sure the attachment is appropriate for the work to be done (see: 4 - ADAPTABLE ATTACHMENTS IN OPTION ON THE
RANGE).
- Make sure the attachment is correctly installed and locked onto the lift truck carriage.
- Make sure that your lift truck attachments work properly.
- Comply with the load chart limits for the lift truck for the attachment used.
- Do not exceed the rated capacity of the attachment.
- Never lift a load in a sling without the attachment provided for the purpose. There are optional solutions ; contact your dealer.
B - MASS OF LOAD AND CENTRE OF GRAVITY
- Before taking up a load, you must know its mass and its centre of gravity.
- The load chart for your lift truck is valid for a load in which the longitudinal position of the
centre of gravity is 500 mm from the base of the forks (fig. B1). For a higher centre of
gravity, contact your dealer.
- For irregular loads, determine the transverse centre of gravity before any movement (fig.
B2) and set it in the longitudinal axis of the lift truck.
It is forbidden to move a load heavier than the effective capacity defined on the lift truck load chart.
For loads with a moving centre of gravity (e.g. liquids), take account of the variations in the centre of
gravity in order to determine the load to be handled and be vigilant and take extra care to limit these
variations as far as possible.
C - LONGITUDINAL STABILITY ALARM
- This device gives an indication of the lift truck’s longitudinal stability. Move the jib very
carefully when approaching the authorized load limit (see: 2 - DESCRIPTION: INSTRUMENTS
AND CONTROLS).
- Always watch this device during handling operations.
- When the device is in alert mode, it is forbidden to perform so-called «AGGRAVATING»
movements, these being:
A - Extending the jib.
B - Lowering the jib.
- Perform movements to relieve aggravation in the following order (fig. C): if necessary,
raise the jib (1), retract the jib as far as possible (2) and lower the jib (3) to release the
load.
The instrument reading may be erroneous when the steering is at its maximum limit or the rear axle
oscillated to its limit. Before lifting a load, make sure that the lift truck is not in either of these
situations.
500 mm
B1
B2
1
2
3
C
Summary of Contents for B-E2 Series
