2 - 32
21 - AIR CONDITIONING CONTROLS (OPTION AIR CONDITIONING)
MLT 523 Turbo Série B-E2
MLT 523 Turbo MONO-ULTRA Série B-E2
The air conditioning only comes on when the forklift truck has been started up. When using your air conditioning, you must work with
the doors and windows closed.
In winter: So as to ensure correct operation and complete efficiency of the air conditioning unit, start up the compressor once
a week, if only for a short spell, so as to lubricate the internal seals.
In cold weather: Warm the I.C. engine before switching on the compressor, so as to allow the coolant that has collected in
the liquid state at the lowest point of the compressor circuit to turn into gas under the effect of the heat given off by the I.C.
engine, as the compressor is liable to be damaged by coolant in the liquid state.
If your air conditioning does not seem to be working regularly, have it examined by your dealer (see: 3 - MAINTENANCE: H - EVERY TWO
YEARS "OPTION AIR CONDITIONING"). Never try to repair any anomalies yourself.
DESCRIPTION OF THE AIR CONDITIONING CONTROLS
A - Control with signal light indicating star t-up and cutout of
the air conditioning system, if control "C" is in position
1, 2 or 3.
B - Heating air temperature control.
C - Air flow setting and fan speed control. In position "0"
the air conditioning system no longer functions.
NOTE: Possible losses of water under the forklift truck are due to condensate discharges caused by the dr ying effect of the
installation, especially with high outside temperatures and high relative humidity.
For the air conditioning to per form properly, the air intakes must not be blocked by frost, snow or leaves.
When the facility is running, at least one of the cab air grilles must be open so as to avoid any risk of freezing to the
evaporator.
HEATING MODE
The controls must be adjusted in the following way:
A - Control with signal light off.
B - At the required temperature.
C - At the required temperature 1, 2 or 3.
CONDITIONED AIR MODE
The controls must be adjusted in the following way:
A - Control with signal light on.
B - At the required temperature.
C - At the required temperature 1, 2 or 3.
DEMISTING MODE
The controls must be adjusted in the following way:
A - Control with signal light on.
B - At the required temperature.
C - At the required temperature 1, 2 or 3.
22 - C
AB FILTER VENTILATORS
MLT 523 Turbo Série B-E2
MLT 523 Turbo MONO-ULTRA Série B-E2
See: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE.
23 - WINDSCREEN DEMIST VENTS
MLT 523 Turbo Série B-E2
MLT 523 Turbo MONO-ULTRA Série B-E2
For optimum effectiveness, close the heating ventilators.
B
A
C
B
A
C
B
A
C
B
A
C
Summary of Contents for B-E2 Series
