Manitou MT 1135 ST3B Instruction Manual Download

Page: 77 / 159

2 - 46

HELP SCREEN

One of these screens appears to inform the operator of the operations to be performed in the current configuration. The
appearance of this screen generates an audible beep.

Maintenance required

(see: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE).

Time to next maintenance in hours

(see: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE).

Engine oil maintenance required

(see: 3 - MAINTENANCE: D - EVERY 500 HOURS SERVICE).

Engine oil maintenance OK.

Shut the door.

Speed too high.

Retract the jib to raise the stabilisers.

MT 1135 ST3B / MT 1335 ST3B

Set down the stabilizers.

MT 1135 ST3B / MT 1335 ST3B

Retract the stabilizers.

MT 1135 ST3B / MT 1335 ST3B

Lower the jib.

Using the attachment circuit in continuous mode and indicating

the hydraulic capacity.

Reset the forward/reverse selector via neutral.

Defective indicator bulb.

Computer over-heat (consult your dealer).

Computer fault (consult your dealer).

Driver presence not detected

(see: 2 - DESCRIPTION: 6 - MAN-MACHINE INTERFACE (MMI).

Parking brake applied.

Hydraulic attachment decompression in progress.

Low fuel level.

Ventilation fault (consult your dealer).

High soot level in exhaust particle filter automatic regeneration

enabled mode (see: 2 - DESCRIPTION: 8 - SWITCHES).

High soot level in exhaust particle filter automatic regeneration

disabled mode (see: 2 - DESCRIPTION: 8 - SWITCHES).

Moderate soot level in exhaust particle filter automatic

regeneration enabled mode (see: 2 - DESCRIPTION: 8 - SWITCHES).

Moderate soot level in exhaust particle filter automatic

regeneration disabled mode (see: 2 - DESCRIPTION: 8 - SWITCHES).

"Stationary lift truck" exhaust particle filter regeneration in

progress (see: 3 - MAINTENANCE: I - OCCASIONAL MAINTENANCE).

Condition not met for "stationary lift truck" exhaust particle

filter regeneration (see: 3 - MAINTENANCE: I - OCCASIONAL

MAINTENANCE).

Exhaust particle filter automatic regeneration enabled

(see: 2 - DESCRIPTION: 8 - SWITCHES).

Exhaust particle filter automatic regeneration disabled

(see: 2 - DESCRIPTION: 8 - SWITCHES).

FAULT SCREEN

IMPORTANT

In any event, stop the lift truck and contact your dealer.

By default, the operator is not permitted to unlock the functions (see: 2 - DESCRIPTION: 6D - SCREEN DISPLAY: MENU SCREEN).

One of these screens appears when the system detects an operating defect on the lift truck. A beep is sounded when this
screen appears.

These defects cause certain functions to be prohibited in
order to ensure safety. However it is possible for the operator
and under his own responsibility (and/or that of the person
in charge of the establishment) to override the prohibition in
order to secure the parking of the lift truck (e.g., unlocking the
hydraulic distributor fault in order to retract and lower the jib).

The unlocking is activated temporarily, the function will be
locked again as soon as the engine is switched off.

Jib raising fault.

Hydraulic control fault.

Fuel gauge fault.

Transmission fault.

Steering fault.

Parking brake fault.

647104

(13/06/2016)

835

/ 1135

/ 1335