PRINTED IN U.S.A.
67
50960025/CP0514
2.
Remove the cover to gain access to the condenser
(2).
3.
Clean any large debris that may have collect on
the top side of the condenser.
4.
Clean the condenser use a jet of compressed air
aimed in the same direction as the air flow.
NOTE:
To aid in the cleaning process, carry out
this operation with the condenser fans running.
5.
Re-install the top cover.
CLEAN/CHANGE CAB VENTILATION
FILTER
NOTE:
Clean or change the filter more often if
there is a noticeable decrease in air flow from the
air vents.
1.
Remove the four screws (1) from the filter pro-
tective cover located on the lower portion of the
dash in front of the brake pedal.
2.
Remove the filter from the cover.
3.
Clean the filter with a jet of compressed air.
4.
Check the condition of the filter and replace it if
neccessary.
5.
Install the filter in the protective cover, then re-
install the protective cover.
If the boom starts to chatter under load, grease the slide
pads and wipe off the excess grease. Maintain a clear-
ance of 1/16” between the top or side slide pads and the
boom. Shims can be added to achieve the proper clear-
ance. Loosen the bolts and insert shims until proper
clearance is obtained.
NOTE:
When inserting shims in the side slide
pads, be sure to place equal shims on both sides
of the boom for even distribution of clearance.
Re-apply Loctite
®
271 (red) thread lock or equivalent
to the bolts and re-torque to 30 ft.-lbs. (40 Nm).
Bottom slide pads should not be shimmed and should
be replaced when the thickness is worn down to 3/8”
(9.5 mm).
CLEAN AIR CONDITIONING CON-
DENSER
NOTE:
Clean the condenser more often if there is
a noticeable decrease in A/C performance.
IMPORTANT:
Do not use a water jet or high-pres-
sure steam, because this could damage the fins.
1.
Remove the six screws (1) from the top cover of
the condenser.
1
2
Top View of Condenser Assembly
1
WARNING
Failure to maintain proper slide pad clearance
and thickness could cause damage to the
boom, resulting in sudden boom failure.
