Installing Ice deflector
1.
Locate correct position for the deflector.
If the ice machine is installed, remove the water trough to obtain easier access.
The deflector must be located in the center of the drop zone.
Location is 11” from the left edge of the ice machine to the left edge of the mounting bracket.
2.
Cut and remove the foam tape on the front and back of the bin where the deflector will be located.
3.
Remove any residual adhesive; areas must be clean and dry.
4.
Remove protective covering from the two sided tape on each deflector bracket.
5.
Install the deflector bracket.
Distribute the mounting bracket equally on the front and back of the bin.
Locate the retaining pin to the back.
Press the mounting bracket into place.
6.
Trim supplied foam tape to length of cuts from step 2 and apply over the top of the bracket. Seal edges
where deflector mounting bracket meets foam tape with silicone sealant to prevent water leakage.
7.
Install the deflector into the mounting bracket.
Align tabs and slide the deflector toward the front of the bin.
Insert retaining pin into hole in the mounting bracket to lock deflector in place.
Reinstall water trough if removed in step 1.
000002544
Sheet 3 of 3
06/13/07
Water
Pump
Location
Water Trough
Located Behind
Splash Shield
Splash
Shield
Ice Deflector
