background image

 

Manitowoc Ice 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA 

 

 

 

 

 

000009168  

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879  

 

 

Page 1 of 4 

Web Site - 

www.manitowocice.com

   

 

 

 

 

 

 

 

 

Rev 01   

 

 

 

 

 

 

 

 

Firmware upgrade instructions for IAuCS  

Only Indigo ice machines with firmware versions 2.032, 2.036 & 2.044 require a firmware 
upgrade - All other firmware versions do not require a firmware upgrade

Use the flash drive 

enclosed with this kit, along with these instructions to upgrade the firmware.

 

 
 

Verify firmware version needs to be upgraded: 

a)  Press menu button - Machine info will be bracketed. 
b)  Press right arrow and select Main SW Ver from submenu (Main Software Version). 
c)  Continue with this instruction when the software version is 2.032, 2.036 & 2.044. The firmware 

upgrade is not required for any other firmware versions. 

 
 
 
 
 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

1.  Remove front door and control box cover 

 

2.  Set the ice machine to off by pushing the power button after the ice falls from the evaporator at 

the end of a harvest cycle. 

 

3.  Navigate the Display Interface to download the current version of Firmware and follow 

instructions 

 

Warning 

Personal Injury Potential 

Failure to upgrade the indicated firmware 
versions can result in continuous dispensing 
of solution into the water circuit. 

Warning 

Personal Injury Potential 

Line voltage is present in the control box 
during this procedure. Use caution when 
inserting USB flash drive in control board. 

Summary of Contents for Indigo

Page 1: ...ted b Press right arrow and select Main SW Ver from submenu Main Software Version c Continue with this instruction when the software version is 2 032 2 036 2 044 The firmware upgrade is not required for any other firmware versions 1 Remove front door and control box cover 2 Set the ice machine to off by pushing the power button after the ice falls from the evaporator at the end of a harvest cycle ...

Page 2: ...hone 920 682 0161 Fax Sales 920 683 7589 Service Parts 920 683 7585 Other 920 683 7879 Page 2 of 4 Web Site www manitowocice com Rev 01 a Menu b Service c USB Setup d USB Stick e Download Frm f Insert Drive g Press Checkmark after inserting drive h Wait for Completion this may take 5 10 minutes ...

Page 3: ...del and Serial number are programmed into the control board Verify the model and serial number on the display matches the model and serial number on the data plate If they match remove the flash drive If they do not match continue with the steps below j Under Service Repl Cntrl Bd Manual Setup Scroll down to the line below the model number k Begin to enter the model number IY ID or IR then press t...

Page 4: ...l number is shown then press the checkmark m Scroll down to serial number and press the Right Arrow Key n Enter the serial number from the ice machine data plate with the up and down arrows If the cursor is not present press the Checkmark to activate the cursor o Scroll down to Exit and press the Right Arrow or Check Mark Exiting will take a few seconds as it is writing the info to memory p Remove...

Reviews: