10
Part Number 000012545 Rev 02 11/16
Installation
Section 2
Ice Machine Heat of Rejection
Series
Ice Machine
Heat of Rejection
1
Air Conditioning
2
Peak
K0250
4600
5450
K0350
3800
6000
K0420
5400
6300
K0500
5300
6100
K0600
9000
13900
K1000
17000
20700
K1350
23900
29000
K1800
29800
34700
1 B.T.U./Hour
2 Because the heat of rejection varies during the ice making cycle, the
figure shown is an average.
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when sizing air
conditioning equipment where self-contained air-cooled
ice machines are installed.
This information is also necessary when evaluating the
benefits of using water-cooled or remote condensers to
reduce air conditioning loads. The amount of heat added to
an air conditioned environment by an ice machine using a
water-cooled or remote condenser is negligible.
Knowing the amount of heat rejected is also important
when sizing a cooling tower for a water-cooled condenser.
Use the peak figure for sizing the cooling tower.
Removing Drain Plug and Leveling the Ice
Storage Bin
n
Warning
To avoid instability, the bin/dispenser must be installed
in an area capable of supporting the weight of the bin/
dispenser, ice machine and a full bin of ice (48" models
1000 lbs [454 kg], 30" models 750 lbs [340 kg]). The bin/
dispenser must be level side-to-side and front-to-back
before installing the ice machine.
1. Remove threaded plug from drain fitting.
2. Screw the leveling legs onto the bottom of the bin.
3. Screw the foot of each leg in as far as possible.
,
Caution
The legs must be screwed in tightly to prevent them
from bending.
4. Move the bin into its final position.
5. Level the bin to assure that the bin door closes and
seals and the ice machine operates properly. Use a
level on top of the bin. Turn the base of each foot as
necessary to level the bin.
6. Inspect bin gasket prior to ice machine installation.
(Our bins come with a closed cell foam gasket installed
along the top surface of the bin.)
7. Remove all panels from ice machine before lifting and
installing on bin. Remove front panel, top cover, left
and right side panels.
Air Baffle
Self-Contained Air-Cooled Only
To install:
1. Loosen the back panel screws next to the condenser.
2. Align the keyhole slots in the air baffle with the screw
holes and slide the baffle down to lock in place.
Air Baffle
