Installation Instructions
Section 2
2-12
Part Number 5031216
01/09
Plain Water Lines
•
Unit has two (2) plain water lines, one for each flex
manifold.
•
Use 2 @ 3/8" x 1/2" elbows and 6-12" of 1/2" conduit
tubing to make connection bend from unit down through
hole in counter top, to mate with conduit.
•
Conduit with only one (1) plain water line
•
Use 1 @ ½” U-bend adaptor, to connect the two plain
water lines to one plain water line from conduit (option to
3.)
•
Conduit has two (2) plain water lines
•
Use 2 @ ½” straight adaptors to connect each plain water
line from unit to each plain water line from conduit as
shown (3.)
Syrup Lines
•
Unit has eight (8) syrup lines
•
Use 7 @ ¼ x 3/8" and 1 @ ¼ x ½” elbows and proper
size conduit tubing to make connection bend from unit
down through hole in counter top, to mate with conduit.
•
FULLY INSULATE (no air gaps) and finish with tape wrap,
all these connections from unit, through 90° bend
connection and down close to straight conduit connection.
Locate Unit properly on counter, and secure to counter as
shown in Unit Installation Instructions. Finish connections
to Conduit with 3/8" x 3.8" and ½” x ½” straight barb
connectors, and U-bend adapters, as needed.
•
FULLY INSULATE and finish with tape wrap, all these
connections to the conduit.
3. Install plumbing drains (see below) and insulate.
Drains
4. Fill bin with ice.
5. Set flexible manifold for correct drink settings.
6. Turn water supply on to the dispenser.
7. Purge air from the carbonator tank. Lift the pressure
relief valve tab on the carbonator tank until water
comes out of the relief valve.
8. Connect the pump deck control lead to the pump motor.
9. Connect power supply cords. (There are (2) two cords
that need to be connected to a 115V power supply.)
10. Brix beverage valves.
90° Elbow Fitting
Radiator Clamp
Flexible Tubing
Straight Fitting Radiator Clamp
Flexible Tubing
Holes for beverage lines
Drainage Through Bottom
Drainage Through Back
Rear View
Radiator Clamp
Holes for drain pan drain
