MAINS CONNECTIONS
Your amplifier has been factory set to the correct mains voltage for your country. The voltage setting
is marked on the serial badge, located on the rear panel. Check that this complies with your local
supply.
Export units for certain markets have a moulded mains plug fitted to comply with local requirements.
If your unit does not have a plug fitted the coloured wires should be connected to the appropriate plug
terminals in accordance with the following code.
GREEN/YELLOW
EARTH
terminal
BLUE
NEUTRAL
terminal
BROWN
LIVE
terminal
As the colours of the wires in the mains lead may not correspond with the coloured marking identifying
the terminals in your plug proceed as follows;
The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which is
marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked by
the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked by
the letter L or coloured RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNEC-
TIONS HAVE BEEN MADE.
The Manley Laboratories Studio Reference 350 watt monoblocks requires a significant amount of AC
current to operate properly. For best operation, plug the amplifier directly into the wall outlet, avoiding
extension cords and other devices which restrict the current supply to amplifier. If extension cables are
required, be certain that they are high quality, heavy duty (14-12 guage) cables.
