GB - 11
Releasing air:
Should the tyre pressure be too high, press the release button (E) and let the air out slowly. Allow the tyre
pressure to fall to the preferred value.
Technical data
Maximum working pressure: 8 bar
Pressure display: 0 - 12 bar (0 - 174 psi)
Length of the filling pipe: approx. 40 cm
Blowguns
Designated use
The blowgun serves to clean and blow out objects and hard-to-reach places.
Start-up operation
Screw the outlet nozzle (F) onto the air outlet.
Connect the blowgun to the pressure pipe of the compressor.
The maximum permitted working pressure (8 bar) must not be exceeded.
Turn the compressor on.
Press down on the trigger lever (D) to start the air supply. The further the trigger lever is pushed down,
the stronger the air jet will be.
Release the trigger lever to stop the air supply.
Detach the tool from the compressor after work has been completed.
Cleaning
Attention! The power plug must be disconnected prior to all cleaning and maintenance work.
Wait until the compressor has completely cooled down. Danger of burns!
The device must be depressurised prior to all cleaning and maintenance work.
Keep the compressor housing free from dust and dirt. Clean the device with a humid cloth on a regular basis.
Do not use detergents or solvents since they could affect the plastic parts of the device. Make sure to prevent
any ingress of water into the inside of the device.
Storage
Disconnect the power plug, deaerate the device and all connected pneumatic tools.
The compressor must be stored in upright position in a dry room which is not accessible for unauthorised
persons.
