GB - 9
•
Make absolutely sure that the crocodile clips do not touch one another once your charger is plugged into the
mains –
danger of short circuit!
Additional safety measures
•
Avoid open flames, as charging lead-acid batteries generates flammable gases.
•
Always use the charger in a well-ventilated place. Do not use your charger in a vehicle or under a closed
bonnet or hood.
•
Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
•
First, attach the crocodile clips to the battery terminals, then plug your charger into the mains.
•
To stop charging, first disconnect the power plug and then the crocodile clips from the battery terminals.
•
Do not allow any battery acid to reach your clothes or skin. If this should happen, rinse out the surfaces
affected with copious amounts of water. Immediately seek medical assistance if battery acid enters your eye.
Appliance description
1. Power plug
2. Black crocodile clip (NEG)
3. Red crocodile clip (POS)
4. Display
5. Mode key
6. Mains cable
Display
1. Battery voltage
2. Battery charge status
3. Motorbike charging program
4. Car charging program
5. 12 V charging program
6. Winter charging program
7. 6 V charging program
Technical specifications
6V mode
12V mode
Operating voltage:
220-240V AC, 50-60 Hz
220-240V AC, 50-60 Hz
Output voltage:
6V DC
12V DC
Max. Charging voltage:
7.4 V
14.6V/14.8V
Charging current:
2,0 A
2,0 A / 4,0 A
Ambient temperatures:
-5°C to +40°C
-5°C to +40°C
Housing IP class:
IP65
IP65
Functions
The charger is suitable for batteries with a capacity of 1,2-120 Ah. It is equipped with a micro-processor. Use the
MODE key to select one of the below mentioned charging modes depending on battery type, battery condition and
environmental conditions. Once you have selected a charging mode, the charger will automatically detect the
connected battery (voltage, capacity, charge status) and calculate the necessary charging parameters (charging
voltage and current). If you select a charging mode unsuitable for the connected battery, or if the battery is
defective or incorrectly connected, the charger will not charge and the fault icon will appear.
