GB - 9
Technical data
Battery powered drill:
Voltage 20
V
DC
Rotation speed, Setting 1.
0 – 400 min
-1
Rotation speed, Setting 2.
0 – 1,400 min
-1
Drill
chuck
10
mm
Sound pressure level (LPA)
87,6 dB (A)
(Uncertainty K = 3 dB)
Sound power level (LWA)
98,6 dB (A)
(Uncertainty K = 3 dB)
Vibration
drilling
1,298
m/s²
(Uncertainty K = 1,5 m/s²)
It is recommended that safety goggles, ear protectors and a face mask are worn during
drilling!
Batteries:
Voltage
20 V DC, 1500 mAh
Charging time
abt. 1 hour
Charging unit
:
Pri:
100-240 V AC/ 50-60 Hz
Sec: 21,5 V DC / 1,5 A
Noise and vibration information
Measured values determined according EN 60745
- The vibration emission level given in this information sheet has been measured in accor-
dance with a standardised test given in EN 60745 and may be used to compare one tool
with another.
- The vibration emission level will vary because of the ways in which a power tool can be used
and may increase above the level given in this information sheet.
-
Try to keep the exposure as low as possible. To reduce the vibration emission level the user
should wear working-gloves and use the machine for limited time.
-
All parts of working cycles have to be considered ( including the time the power tool is
switched off, and the time, when the power tool is running under no-load condition).
Charging procedure
Before their first use, the battery set (6) must be loaded.
Only use the provided adaptor (10) to charge the battery set.
Only charge the battery set when the ambient temperature is within 10° - 40° C.
Plug the adaptor (10) to a 230V alternating voltage source.
The battery set (6) should under no circumstances be disassembled.
To remove the battery set, press the attachment clip (7) on the top side of the battery set
and extract the battery set (6).
Connect the plug of the charger to the loading-socket (9) of the battery-set.
Red LED will light once the battery has been connected to the charger and the charging
procedure will proceed.
