10
Tips
It will be faster for transferring of waste oil from transparent measuring glass into oil tank, if vacuum
generated in both transparent measuring glass and oil tank.
Tank Emptying
When the oil retained in tank near full(see oil window), You need to eject oil out into a disposal tank and resolve
the waste oil accordingly to the instruction of local government.
1.
Turn off all the valves.
2.
Hold the ejection hook and insert it into the external disposal tank.
3.
Connect the air compressor with the air inlet
○
4 .
4.
Turn on wing valve
○
5 for oil ejection.
5.
Turn on the mini ball valve
○
4 gradually, adding tank pressure, turn off air compressor when pressure reach
to desired pressure. (The safety valve will automatically release pressure when the tank pressure reach 1.0
bar/14PSI, turn off the mini ball valve
○
4 immediately and quickly drop the tank pressure below
1.0bar/14PSI, otherwise it could lead to serious incident).
6.
Cut off air source after ejection, empty tank pressure and turn off all valves.
Notice: The tank capacity is 70L. It suggest to drain the waste oil
from the tank before the volume of waste oil reach the scale at
55L STOP position.
Note: The space at top of the tank is reserved for air. During the
oil drain process, the tank will contain pressure after the air is
compressed. Air pressure cannot be over 1Bar, so that it will
accelerate the oil draining.
Suggestion: After drain oil from the tank, please release
remaining air in the tank.
WARNING!!!
1.
The ball valve
○
3 (FIG.9) must be closed in order to prevent air enter causing transparent measuring
glass damaged.
2.
Please hold the end of Ejection Hook to avoid waste oil spattering out, cause an injury of
eye, dirty of clothes.
3.
Before disconnect extraction/ejection tube with fast couple (male), making sure no any pressure existed
