5
6.
Always protect your skin and eyes from contact with oil and solvents.
7.
Do not start engine during the time of oil extraction. Otherwise it will cause the damage of extraction probes
and injuries of people.
8.
Be careful for the oil extracted out from the vehicle, as temperature of oil is high, always between 40~60
℃
.
9.
Used oil should be properly disposed or recycled. Please contact with your local waste liquid/solid authority
for information on recycling.
10.
Can be used with other mechanical engine oil, lubricants as well as temporary storage. Brake fluid, gasoline,
diesel and other liquid contains methanol and ketones or flammable is strictly prohibited.
Warning
1.
Please read this Manual Book carefully and fully understand it before operation.
2.
In order to avoid the aging of the rubber parts, do not expose the machine in the sunshine; do not deposit the
machine in a moist place, it must be stored in a dry place with good ventilation. Because of the multi functions,
the machine is equipped with many accessories, it must be cared by a special technician.
3.
This machine has been tested strictly before leaving our factory, but the operator must obey our operation
regulations. Please do not try to take apart and repair it by yourself, if you meet with any faults, please contact
our local distributors or our company.
4.
After using, always cut off connection with air compressor and recover all the pipe to its original place.
5.
Do not lower than the min. air inlet required pressure. Do not exceed the max. air inlet required pressure.
6.
Do not dismantle this machine by unqualified or unauthorized personnel. Otherwise will avoid warranty.
7.
If you have any inquiries, please contact our local distributors or service offices.
8.
Air inlet & Oil drain: Ball valve must be closed operation confirmation.
Transport and unpacking
When unpacking, check to make sure that all the parts are included. Refer to the Assembly section, and the
Assembly Drawing and Parts List at the end of this manual.
For transport of the packaged product, refer to Fig.1 below
Once the product has been unpacked, check that the instructions manual is there, that the material is complete and
