Image 1.
Image 2.
Image 3.
4. How to fit sandpaper center
5. Maintenance
In order to fit center of sand paper, the Housing and Control bolt(right side) need to be adjusted with delicate.
After putting sand paper, prepare 3.5mm L wrench and clear the control bolt if it is dirty. and follow below
instructions.
- Prepare 3.5mm L wrench.
- Use a wrench to tighten the bolts and loosen them as seen in Image 1
- If upper bolt is tightened, sand paper goes to Left. as seen in Image 2.
- If bottom bolt is tightened, it goes to Right as seen in Image 3.
- After fixing the center, check all bolts are tightened exactly.
WARNING : When fitting center of sand paper, you must use the genuine sand paper manufactured by
Manpatools. Sand paper in the market have different regulations that working without properly installing
may result in an accident
.
Housing
Drive
Roller
Clean the housing part after
working.
Clean the sawdust on the drive
roller. The paper may be torn.
If the paper is worn, replace it.
Control bolt
3.5mm L
wrench
Upper Bolt
Bottom Bolt
Sand
paper
Always attach the handle and hold
the tool with both hands.
Check that the body and the grinder
are in complete contact.
