USE AND CARE GUIDE
CHECK THE WATER WHEN YOU BEGIN FILLING TO ENSURE IT IS AT A SAFE TEMPERATURE.
Congratulations on the purchase of your new walk-in tub. By carefully following your new walk-in tub’s
instructions, you can benefit from the safety, dignity, independence and a tremendously improved quality
of life.
Please read the following instructions before using your walk-in bath and retain for future reference.
Proper door handle use:
Even though the handle is fabricated from the strongest materials available it will not withstand use of
excessive force to close the door or use as a grab bar. If used in either of these ways the bottom of the
handle may break away from its fixing. The handle is designed as an opening and closing mechanism for
the door.
Using your Walk-in Tub
RESTORE ACR General Instructions
Enter the bath and sit if desired. Next, close the door and seal it by pushing the handle forward into the
locked position. Close the drain by turning the handle at the overflow counter clockwise. With the pre-set
thermostatic mixing valve (professionally installed by your plumber) it is only necessary to turn on the hot
water. However, if a cooler bath is desired, turn on the cold water to mix with the hot water. Fill the bath to
a depth to best suit your needs. When the bather is done, drain the bath by turning the handle clockwise.
After the bath is fully drained, open the door by pulling backward on the door handle and carefully exit the
tub.
RESTORE Air Bath – Model 8490 or 8590
IMPORTANT
It is recommended that bathers should limit their use of the air system to not more than 20 minutes in any
one bathing session.
OPERATION
BUTTON 1, WHITE LIGHT - POWER ON/OFF
The first button is the power button which will activate the
keypad and illuminate in dim colors.
BUTTON 2, BLUE LIGHT - BLOWER
Push
the button once to activate blower, push
again to turn off.
BUTTON 3, YELLOW LIGHT - LIGHT
SYSTEM
Push the button once to activate
the light system. Continue to push button
until desired color is reached or lights are
turned off. Push and hold button for two
seconds to power off immediately.
BUTTON 4, RED LIGHT - SURFACE HEATER
(if equipped)
Push the button once to activate the heated seat and backrest, push again to turn off.
NOTE:
BLOWER TIMER
- The system is equipped with a 20 minute timer. The blower will turn off automatically
after the time has elapsed.
PURGE AND DRY CYCLE
- A one minute purge and dry cycle will activate 20 minutes after the Blower
is turned off. When the bather is finished, the water should be drained. The blower will reactivate 20
minutes after it is turned off and will run for one minute. The blower will turn back off after one minute.
