AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
24
Programming functions Register 2 continued
Vehicle set up: Open a door, close bonnet & boot, arm & disarm alarm then turn ignition on, off & on.
Feature:
Anti Hijack – Mode 2
Press the
button
this many times:
10
Factory setting:
OFF
Description:
When this feature is turned ON, the unit will enter anti hijack mode 2 when the ignition
is turned on. Upon entering anti hijack mode, the unit will begin waiting for a disable
notification by pressing the momentary switch. The LED will flash during the
countdown to notify the user it is in anti hijack mode (can be turned off via Register 2,
Feature 14).
If this is not performed within 30 seconds of the ignition being turned on, the siren will
emit four warning chirps and the indicators will flash. 30 seconds later if the switch has
still not been pressed, the unit will trigger the anti hijack mode. Immobiliser 3 (fuel
pump) will open, immobilising the vehicle and will stay open until the ignition is turned
off then on and the momentary switch is pressed or pin code is entered. The alarm will
also activate for five minutes after the anti hijack trigger (can be turned off via Register
2, Feature 11).
Feature:
Alarm on Anti Hijack trigger
Press the
button
this many times:
11
Factory setting:
ON
Description:
When this feature is turned ON, the unit will alarm if anti hijack is triggered. The alarm
will sound for five minutes after anti hijack is triggered or until the ignition is turned off
then on and the momentary switch is pushed or the PIN code entered.
Feature:
Single relay cut on Anti Hijack activation
Press the
button
this many times:
13
Factory setting:
ON
Description:
When this feature is turned ON, the unit will only immobilise the immobiliser three
circuit on an anti hijack trigger. This is to prevent any injuries to people or damage to
the vehicle from immobilising the ignition while the car is moving. When this feature is
turned OFF, the unit will immobilise all immobiliser circuits which is not recommended.
Feature:
LED flash on pending Anti Hijack activation
Press the
button
this many times:
14
Factory setting:
ON
Description:
When this feature is turned ON, the LED will flash during the countdown to the anti
hijack trigger. This is used to inform the driver of the impending trigger and remind
them to press the momentary switch.
