AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
4
Anti hijack modes
25
Courier mode
26
Central door lock diagrams
Negative pulse CDL system
Positive pulse CDL system
Reverse polarity CDL system
Vacuum CDL system
Single
wire
CDL
system
.........................................................................................................................................................
Flow thru CDL system
27
28
Remote boot release diagram
28
Timed headlight diagram
29
Optional siren diagrams
29
3 extra control channels from AVS remote (requires RXPRO/RCX-4)
30
Trouble shooting guide
31
Introduction
Please read the entire instruction manual before attempting installation. As all cables are black please take care when
making all connections.
Insurance star ratings are only valid when installed by a registered AS/NZS installer
and installed in accordance with methods and principles detailed in AS3749.2
PLEASE ENSURE ALL CONNECTIONS ARE SOLDERED AND TAPED. DO NOT USE SCOTCH LOCKS OR SIMILAR
CONNECTORS.
General system features
Poly-fuse protected inputs/outputs:
The AVS S-Series includes poly-fuses on all inputs and outputs except the immobiliser circuits. If the poly-fuse
detects an overload, it will open to prevent damage to the alarm components. Once the overload has been removed
the polyfuse will automatically reset. If you find a circuit does not work (i.e. central locking operates several times
then stops) check the current draw on the affected circuit, as it may be too high. The polyfuse may take several
minutes to reset.
Auto-immobilisation:
The AVS system will automatically immobilise 38 seconds after the ignition is switched OFF. The LED will light solid
to indicate it is in auto immobilise mode.
Arm by remote:
Press the
button on the remote. The indicators will flash once and the siren will chirp once (if fitted). If the
central locking is connected the doors will lock. The LED light will stay on solid for 38 seconds and then flash.
Silent arm: Push the
and
button together.
Door ajar warning:
If the siren chirps for three seconds on arming, a door, bonnet or boot is open. The alarm will exclude that zone until
it is properly closed and the alarm is disarmed then armed again.
Disarm by remote:
Press the
button on the remote. The indicators will flash twice and the siren will chirp twice (if fitted). If the
central locking is connected the doors will unlock. The LED will stop flashing.
