MM201 -
CD & RADIO PLAYER
8
Do not stick labels or tape on the discs, and do not
scratch or damage the discs.
The disc spins at a high speed during playback.
Do not use damaged, cracked, or warped discs
because they could damage the unit.
Disc Cleaning
Fingerprints or dirt on disc surfaces can weaken the
light reflected from the disc and directly influence the
signal quality. The poorer the signal quality, the poorer
the playback performance. Keep the disc clean by
wiping it straight out from the center with a dry soft
cloth.
If the disc is very dirty, wipe with a moist soft cloth,
then follow with a dry soft cloth.
Do not use record cleaning sprays, benzene, thin-
ner, anti-static electricity liquids, or any other solvent.
These may damage the disc surface.
Disc Storage
Please keep the discs in their original cases to avoid
bending the discs. Do not keep discs in locations with
high temperature, high humidity, or direct sunshine.
These conditions may also cause damage to the discs.
Carefully read all instructions on the disc label.
Power Supply
AC power operation
Connect one end of the mains lead to (AC-In) socket
and the other end to an AC outlet.
Battery power operation
Open the battery compartment lid by pushing
down on the tabs.
Install 6 x “C” size batteries (not suppled). Refer
to the polarity diagram in the battery compartment
of the unit. Match the (+) and (–) marks on the
diagram to the (+) and (–) marks on the batteries.
Caution!
When installing batteries
To prevent battery electrolyte leakage, which may result
in injury and damage to the unit or other objects, observe
the following precautions:
All batteries must be installed with the proper polarity
(see diagram in the compartment of the unit).
Do not mix new with old or used batteries.
Only use batteries of the same type and brand.
Remove the batteries when they are not to be used
for a long period time.
