M
ANTARO
B
OT
T
ELE
M
E
2
Assembly Instructions &
Quick Start Guide
MantaroBot™
20410 Century Boulevard
Suite 120
Germantown Maryland 20874
www.MantaroBot.com
info@mantarobot.com
Phone 301 528 2244
Fax 301 528 1933
13
6.
Click on the ‘Wifi Connection Page’ link at the bottom of the webpage and the screen shown
below will appear.
7.
From the list shown, select the Wifi network that the MantaroBot TeleMe 2 should use for
normal operation and click ‘Connect'. You may be required to enter an administrator username
and password. An initial administrator account was setup prior to the shipment of the TeleMe 2
and can be found on the Information sheet that was shipped with the robot. To connect to a
hidden network (e.g. network whose SSID is not broadcasted) click “Connect to hidden wireless
network” and enter the requested information. Most networks require a network security key
or passphrase. To connect ask your network administrator or Internet service provider (ISP) for
the security key or passphrase.
8.
If connecting to the selected network was successful, a series of audible beep-tones will be
heard and the LED on the device holder will be lit and not flashing. Now, turn the TeleMe 2
power off and back on using the push button on the device holder. Wait for the LED to turn off
completely before turning it back on.
9.
Your TeleMe is now configured for normal operation. The Wifi connection of the
tablet/smartphone can be changed back to the network it is normally configured for.
