symptoms
Possible causes
Solutions
The learning cycle does not start.
The LED blink 4 times
The battery pack is empty
Wait 6 to 8 hours before using the
shutter.
The learning cycle does not start.
The LED is ON
The order is defective
Verify that protective cover of the
battery is removedVerify that the
battery is not defective (the LED is ON
while pushing)
The learning cycle does not start
The LED is OFF
The order is defective
Verify that protective cover of the
battery is removedVerify that the
battery is not defective (the LED is ON
while pushing)
The motor is not powered
Verify the plug between the control
box and the power supply Verify the
power supply connection
The opening button make the
shutter closing
The order is inverted
Proceed to the reversal of the functions
of the transmitter buttons
(see programming instructions)
The closing button make the
shutter opening
The order is inverted
Proceed to the reversal of the functions
of the transmitter buttons
(see programming instructions)
The shutter does not start when there
is an opening or closing order
The order is defective
Verify that the battery is not defective
(the LED is ON while pushing)
The battery pack is empty
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
The shutter does not close completely
There is an obstacle or bad learning
Remove the obstacle and/or do a
learning cycle again
The battery pack is empty
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
The shutter does not close completely
There is an obstacle or bad learning
Remove the obstacle and/or do a
learning cycle again
The battery pack is empty
Verify the electrical wire plug : Wait 6
to 8 hours before using the shutter.
The shutter is hardly closing
Bad learning
Do a learning cycle again
The shutter is hardly opening
Bad learning
Do a learning cycle again
The drive is noisy (popping noise)
Belt relaxed
Tighten the belt
DIAGNOSTIC HELP
Reversal of the functions of the transmitter buttons
This operation is necessary in case where the shutters open by pressing the (>< ) button of the transmitter.
Position the shutters near the ‘close’ position (approx. 10 to 15 cm). In this new position, start again the operation Learning mode
and saving.
NM V323
A
09-2014
MANTION SAS
- 25000 Besançon - Tel +33 3 81 50 56 77 - Fax +33 3 81 85 38 79 - www.mantion.com
20/20
