2
WARNING:
important safety instructions.
These instructions must be followed in the interest of personal safety; Keep
these instructions.
WIBAT is exclusively designed for opening and closing swing shutters. It must not be used for any
purpose other than that specified in these instructions. The manufacturer or supplier shall not be liable
for any damage resulting from improper use thereof. The user alone shall be solely liable and assume
any risks arising from improper use of the product.
This shutter motor must be installed by persons fully aware of the hazards involved in currents,
drilling and chemical sealing who have the requisite qualifications to work on domestic installations
in accordance with good practice.
Follow all the instructions because faulty installation can cause injury.
The assembly steps must be followed, as must the operating instructions, and safety rules must
always be heeded.
Before installing the shutter motor, check that both the driven part and the entire WIBAT are in good
physical condition and that the structure has the necessary load-bearing capacity for the WIBAT in its
entirety.
The electrical installation must be done according to prevailing national standards and in accordance
with all legal obligations and/or prevailing obligations to that effect.
(Electrical compatibility: voltage and frequency as marked on the product and that of the power
network where it will be used.)
Do not connect the device without first checking that the control
circuit is dead.
Check the installation frequently to detect any imbalances or signs of wear or damage. Do not use
the device if it needs repairing or adjusting.
Disconnect the power supply when cleaning it or carrying out other maintenance or servicing
tasks.
Never modify or fit any additional parts to the device that may compromise safety without MANTION
SMT's written permission.
Be very careful not to get your fingers caught when using the device.
The user alone is solely and entirely responsible for any breach of these safety rules, and any
damage resulting therefrom.
The product must be stored indoors in a dry place at a temperature of between 0°C and +45°C.
When fitting it, the installation engineer must heed accident prevention instructions and the
standards in force in the country.
Do not immerse the gear motor in water or splash it.
Do not dispose of it in fire or bring it into contact with flame or any heat source.
Do not use household products or chemicals to clean it. Only use a moist sponge and soap.
Do not dispose of the packaging in the environment; treat waste according to the standards in
force in the country
.
Keep products, devices and documentation out of reach of children.
Do not let children play with the fixed control devices. Keep remote controls out of reach of
children.
When using a switch without a lock, make sure everyone else is kept at a distance.
Use only the MANTION SMT-approved embedding kit and drilling equipment.
