Pro Electric Chainsaw Operator’s Manual
11. Technical Data
This chainsaw has been built in accordance with Regulation DIN EN
60745-2-13 and fulfils the requirements of the European law on equip
-
ment safety.
electric Chainsaw
8530-00-38 & 8530-00-40*
Rated Voltage V~
230
Nominal Frequency Hz
50
50Fuse (time lag) A 16
Rated Output W 2500
Nominal current A 11,3
Guide Bar mm 400
Cutting length
mm
380
Speed m/sec ca. 12.5
Weight kg 5.2
Oil ml 250
*
(KSe 2540 Pro)
All models with automatic chain lubrication and mechanical chain brake
and rundown brake.
The type designation of the chain you will find on the type plate.
Class of Protection: II/ DIN EN 60745-1
Interference Suppression: according to EN 55014
Noise emission values EN 60745-2-13:2011-07:
Sound Pressure Level L
pA
90 dB (A) K=3.0 dB (A)
Vibration values in accordance with EN 60745-2-13:2011-07:
Weighted acceleration handle max. 7.3 m/s
2
K=1.2 m/s
2
attention: This chainsaw is only intended for cutting wood !
12
8. In the Case of Technical Problems
• The machine does not start up:
the thermal overload switch has
triggered, wait for the cool-down period, see 4.6. Check whether the
current socket is live. Check whether the power cable is undamaged.
If neither case applies, take the chainsaw to a specialised workshop
or the works after-sales service.
• Chain does not run:
Check position of handguard (see ill. 8). Chain
only runs if handguard brake is released.
• Chain does not cut at all :
Chain is not mounted to the correct direc-
tion. Aseemble the chain to the correct direction.
•
Sparks fly at the motor:
Motor or carbon brushes damaged. Take the
chainsaw to a specialised work-shop or the works after-sales service.
•
Oil does not flow:
Check the oil level. Clean the oil flow openings
in the bar (see also the corresponding hints of “Maintenance and
servicing). If this is not successful, take the chainsaw to a specialised
work-shop or the works after-sales service.
attention: any maintenance or repair work going beyond that
described in these operating Instructions may only be carried
out by authorised persons or the works after-sales service.
attention: If the power supply lead of this device shows any
defects, the lead must be replaced by an authorized repair
shop only or through the manufacturer’s own service per-
sonnel, as this work requires special tools.
9. Repair Service
Repairs to electric power tools should only be carried out by specialist
electrical personnel.
Always keep the original packaging for a possibly required shipping of
the tool.
UK
Mantis UK Limited
Orchard House
Hempshaw Lane
Stockport
Cheshire SK1 4LH
Phone - 4401614741525
europe
Mantis France SARL
20 rue des Garennes
57155 Marly
France
Tél 330387628888
Or contact your local Mantis authorised dealer.
10. Waste Disposal and environmental Protection
If your chainsaw should become useless somewhere in the future or
you do not need it any longer, do not dispose of the device together with
your domestic refuse, but dispose of it in an environmentally friendly
manner. Please dispose of the device itself at an according collecting/
recycling point.
By doing so, plastic and metal parts can be separated and recycled. In-
formation concerning the disposal of materials and devices are available
from your local administration.
Properly dispose of packaging material that is not required any longer via
your local waste paper disposal system.
