31
PROBLEM
REASON
SOLUTION
4. Steady stream of steam/
drops of water noticed
from the safety button
console.
5. Steam is escaping
around the edges of the lid.
g. Make sure that the
pressure regulator on
the vent tube is in the
locked position.
a. Ensure that the lid
is fully closed and the
2-way safety button
is aligned to “Close”
position
b. Wait for some time and the
steam emission around the safety
button console will stop once the
pressure builds up.
a. Make sure the
rubber gasket is clean
and well positioned.
If worn out replace.
g. The pressure regulator is not
placed properly and locked.
a. The 2-way safety button is not
aligned to “Close” position.
b. Even when closed properly initial
emission of steam/drops of water
condensation will collect on the lid
near the safety button console as the
multifunction safety plug has to seal
completely with the pressure build
up signalled by the VPI rising
.
a. The rubber gasket is not in place
or worn out.