Maple Systems HMI5043DL, Installation Manual

10

                             HMI5000L Installation Guide

1010-1018 Rev 13                                                                          www.maplesystems.com

Configuration Wiring

To configure the HMI using the EasyBuilder Pro software, use the 
Ethernet Configuration Cable (P/N 7431-0104) or USB Configuration 
Cable (P/N 7431-0115).

Configuration Cable

HMI Model

P/N 7431-0104

Ethernet 

(Crossover)

P/N 7431-0115

Mini USB

HMI5043Lv2, HMI5043LBv2, 
HMI5043DL, HMI5070L,
HMI5070LB, HMI5070DL,
HMI5070NL, HMI5071L,
HMI5097DXL, HMI5097NXL,
HMI5100L, HMI5102L,
HMI5103L

X

HMI5120XL, HMI5121XL, 
HMI5150XL

X

X

USB

A USB driver (included with the EasyBuilder Pro software) must be 
installed when downloading from the PC to the HMI via USB connection.

Caution: 

When connecting two powered devices via USB, a 

difference in potential can exist between the ground reference on 
each device. If there is a difference in ground potential (voltage), 
making a connection via a USB cable can complete a ground 
loop that may damage the HMI and PC. The Maple Systems 
USB Configuration Cable (P/N 7431-0115) is recommended for 
connecting the HMI to the PC. The shield is not connected 
between the two ends of the cable, which will prevent a 
potentially damaging ground loop from occurring between the 
devices. Please refer to Page 6 for proper wiring instructions.