Installation and Startup Guide
This document covers the installation of iR-ETN, for the detailed specifications and operation, please
refer to Datasheet, Brochure and Remote I/O User Manual. Please read all warnings, precautions, and
instructions on the device carefully before use.
Install Environment:
Electrical
Environment
The
product has been tested to conform to European CE requirements. This
means that the circuitry is designed to resist the effects of electrical noise. This
does not guarantee noise immunity in severe cases. Proper wire routing and
grounding will insure proper operation.
Environmental
Considerations
(1) Make sure that the units are installed correctly and that the operating limits
are followed.
(2) Avoid installing units in environments where severe mechanical vibration or
shocks are present.
(3) Do not operate the unit in areas subject to explosion hazards due to
flammable gases, vapors or dusts, or where acid gas, such as SO2 exists.
(4) Relative Humidity: 10% ~ 90% (non-condensing)
Unpacking the Unit
Unpack and check the delivery. If damage is found, please contact the supplier.
NOTE:
Place the unit on a stable surface during installation. Dropping it or letting it fall may
cause damage.
The package includes:
(1)
Installation Instruction, 2-sided A4 *1
(2) Warranty Statement *1
(3)
iR-ETN *1
(4)
Power Connector *1
(5)
Spare Clips *2
Installation Instructions
Clip assembly: Insert one side of the clip into the hole on the
case. Press down firmly in the direction shown in the figure
on the right until hearing the clip
snap into the case.
Clip removal: Insert a flathead
screwdriver into the gap on the clip
and then lift up the screwdriver.
Placing a finger on the clip when
lifting the screwdriver can prevent
the clip from jumping away. The clip
can also be removed directly by
hand.
Rail mounting: DIN rail 35mm.
Panel mounting: Use two M4 or #8 panhead screws, mounting hole size is 4.6mm
Plan for adequate space around the unit and inside the enclosure, for ventilation and cables. Consider
the heat from other devices inside the enclosure. The ambient temperature around the unit must be 0
~ 5
5
°C
NOTE: Please do not touch any of the connectors when the unit is powered up and running.
Power Connections
Power Connector Specifications:
Wire AWG: 28~12
Operating Temperature: -40°C ~+105°C
Screw Torque: 3.47 lbf-in (max.)
NOTE:
Connect positive DC line to the ‘+’
terminal and the DC ground to the ‘-’ terminal.
Communication Connections
RJ-45
Name
Description
1
TD+
T
2
TD-
Transmit-
3
RD+
4
….
5
….
6
RD-
Receive-
7
….
8
….
Case
iR-ETN series
Installation Instruction
3
5
4
1
2
