Appendix B
Agency Ratings
UL Class I, Division 2 Groups A,B,C,D hazardous locations.
Environmental Type 4, 4x (indoor), 12
European Union Directive Compliance
If this product is installed within the European Union or EFTA regions, the following regulations apply:
This apparatus is tested to meet Council Directive 89/336 Electromagnetic Compatibility (EMC) Standards:
• EN50081-2
Class A (Industrial) Emissions
• EN50082-2
Class A (Industrial) Immunity
According to these Standard, the factor which determines, for EMC purposes, whether an apparatus is
deemed to be “industrial” or “Residential, commercial and light industrial”, is given in Clause 1 of
EN50081-2 as follows:
Apparatus covered by this standard is not intended for connection to a public mains
network but is intended to be connected to a power network supplied from a high-
or medium-voltage transformer dedicated for the supply of an installation feeding
the manufacturing or similar plant.
The product described in this document is intended for use solely in an industrial environment as defined
above. When installed in Europe, any other application is in contravention of European Union Directives,
and a breach of those laws.
1010-0104, REV 03
22
OIT3185A/4185A
INSTALLATION MANUAL
3
1010-0104, REV 03
Read Me First!
Your new Maple Systems OIT comes from the factory without any
communications protocol or operational software installed; therefore
•
The OIT will NOT operate until it has been configured using
OITware-200 or STEPware-100.
•
When power is first applied, the OIT’s display will indicate that it
needs to be configured.
•
Use the OITware-200 or STEPware-100 software to create a file
(or “project”) that can be downloaded to the OIT.
•
When the project is transferred, both communications protocol
and operational software are automatically loaded and the unit is
ready for operation.
To ensure that the OIT meets UL and CE compliance, it is
necessary to follow all installation procedures described in this
manual.
