5.3. Installing the Slide-In Legends
To replace the factory installed legends with your own:
1. Ensure all paints, ink and fixative are thoroughly dry and will not transfer.
2. Place the unit face down on a clean protective surface.
3. Remove the four mounting nuts, which hold the bezel (frame) to the main
assembly, from the back of the unit.
4. Lift the main assembly out of the bezel and place it face up on the clean
protective surface.
5. Locate the four legend pockets, refer to Figure 18.
6. Carefully remove the factory installed legends.
7. Slide in the new legends:
• be gentle
• avoid wrinkling, which makes it hard to push the legend in
• if the legend moves around too much, put a curl in the paper
NOTE:
The legends are made long to facilitate removal.
8. Be sure not to tape over the ends of the inserts, as this could cause a leak
where the bezel gasket seals.
INSTALLATION MANUAL
21
1010-0081A, REV 04
1
(LEFT)
CLEAR
DELETE
9
8
7
2
(MIDDLE)
3
(RIGHT)
DOWN
PAGE
HELP
TOGGLE
0
.
PAGE
UP
NEXT
MESSAGE
4
SETUP
LAST
MESSAGE
SCREEN
1
5
ALARM
ACK
6
2
3
N
E
R
T
E
Function Key Legends
Logo Legend
Main Assembly
Figure 18 Custom Legend Installation
