OMI Operations Manual: OMI6700 Series
32
OMI Operations Manual: OMI6700 Series
32
TOUCH SCREEN
The OMI6700 Series includes an analog resistive touch screen. An application is pre-
loaded onto your OMI6700 Series which allows you to calibrate and change the settings of
the touch screen.
Touch Screen Calibration
The touch screen may need to be recalibrated from time-to-time. There are two calibration
meth
ods: ‘Standard Calibration’ and ‘Advanced Calibration’:
Standard Calibration: The simpler of the two methods, this method can be used for
most touch screen calibrations required.
Advanced Calibration: As your OMI6700 ages, the touch screen may require finer
adjustments which can be accomplished using this method.
1.
Click “Start”, then “All Programs”, and
select “PenMount Windows Universal
Driver (WHQL)”.
Open the “Utility” folder and click
“PenMount Control Panel”
When the PenMount Control Panel
window op
ens, select “PenMount 6000
RS232
” and click “Configure”.
2.
Select “Standard Calibration” or
“Advanced Calibration”.
“Turn off EEPROM storage”- this option
will disable writing any calibration data to
the EEPROM controller. Default is
enabled.
