H/P Amp Gain
Set the gain of the headphone amplifier. Set this according to the
impedance of the connected headphones. It is recommended that this is
set on the “Low” side if the headphones have low impedance and on the
“High” side if they have high impedance.
High:
Set the gain of the headphone amplifier to
“High”. Set when there is insufficient volume,
even when the gain setting is “Mid”.
Mid:
Set the gain of the headphone amplifier to
“Mid”. Set when there is insufficient volume,
even when the gain setting is “Low”.
Low
(Default):
Set the gain of the headphone amplifier to
“Low”.
NOTE
0
The headphone volume varies depending on the “H/P Amp Gain” setting.
Decrease the volume or mute the audio first if changing this setting while listening
to audio.
Filter
This unit is equipped with a sound quality adjusting function which allows
users to enjoy the desired playback sound quality. The unit supports PCM
signal.
Filter 1
(Default):
Offers a short impulse response for both
pre-echo and post-echo. Large amount of
audio information clearly reproduces deep
stereo imaging and the relative position of
the sound source.
Filter 2:
Both pre-echo and post-echo are slightly
longer. The sound characteristics is edge
and powerful.
35
