Bass
Set subwoofer and LFE signal range playback.
o
Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE
(Default)
:
The low range signal of the channel set to
“Small” speaker size is added to the LFE
signal output from the subwoofer.
LFE+Main:
The low range signal of all channels is
added to the LFE signal output from the
subwoofer.
0
“Subwoofer Mode” can be set when “Speaker Config.”
-
“Subwoofer” is set to
other than “No”. (
v
p. 247)
0
Play music or a movie source and select the mode offering the strongest bass.
0
If “Speaker Config.”
-
“Front” and “Center” are set to “Large”, and “Subwoofer
Mode” is set to “LFE”, no sound may be output from the subwoofers,
depending on the input signal or selected sound mode. (
v
p. 247) Select
“LFE+Main” if you want the bass signals to always be produced from the
subwoofer.
o
LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80 Hz
/
90 Hz
/
100 Hz
/
110 Hz
/
120 Hz
/
150 Hz
/
200 Hz
/
250 Hz
(Default : 120 Hz)
Contents
Connections
Playback
Settings
Tips
Appendix
255
Front panel
Display
Rear panel
Remote
Index
