9
Connecting other equipment
Remote control jacks connection
If this unit is connected to a Marantz amp, the amp can be controlled via this unit using the
Marantz Remote App or web control function (
). Also, remote control signals
received by the amp can be used to control this unit.
n
Connection
Use the supplied remote connection cable
to connect the REMOTE CONTROL IN
terminal of this unit to REMOTE CONTROL
OUT terminal of the amplifier.
n
Setting
Set the remote control switch on the rear
panel of this unit to “EXT.” to use this
feature.
• This setting will disable remote sensor
reception of this unit.
• To operate the unit, point the remote
control at the remote sensor of the
amplifier.
To use this unit without connecting it to the
amplifier, set the remote control switch to
“INT.”.
Amplifier
Set to “EXT.”
The unit
RS-232C
Connect an external control device or other
device for servicing. (Use a straight cable for
the connection.)
External control device
FLASHER IN
This unit can be controlled by connecting a
control box or other control device to this unit.
Control box or control device
GND
Signal
Monaural mini-plug cable
To use the FLASHER IN jack, set the remote
control switch to “INT.”.
Preparation
Operation
Information
Preparation