14
General Settings [General]
Upgrade
Display a notification message on this unit’s menu screen
when downloadable firmware is released with “Add New
Feature”.
Connect to broadband Internet (
) when using
this function.
1
Press
MENU
.
Turns on the Menu settings mode
and the Menu appears on the
display (
2
Use
ui
and
ENTER
to select
“General” – “Firmware” –
“Notification” – “Upgrade”,
then press
ENTER
or
p
.
“Upgrade Notification” menu
appears.
3
Use
ui
to select “On”, then press
ENTER
or
p
.
On
Display upgrade message.
Off
Do not display upgrade message.
• When you press
ENTER
during display of the notification
message, the “Add New Feature” is displayed. (Refer to
for more information on “Add New Feature”.)
• Press
o
to erase the notification message.
n
Add New Feature
• In order to add new functions, the environment and settings
required for connecting to broadband internet are needed
).
• Perform the add new feature operation after at least 2
minutes has elapsed since turning this unit’s power on.
1
Press
MENU
.
Turns on the Menu settings mode
and the Menu appears on the
display (
2
Use
ui
to select “General”
– “Firmware” – “Add New
Feature”, then press
ENTER
or
p
.
Upgrade Status
Display a list of the additional functions
provided by the upgrade.
Upgrade Start
Execute the upgrade process.
• If the upgrade is not successful, an error message identical
display. Check the settings and network environment, then
update again.
Upgrade ID
The ID number shown on this screen is
needed when carrying out the procedure.
See the Marantz website for details about updates.
When the procedure is complete, “Registered” is displayed
and updates can be carried out. If the procedure has not been
carried out, “Not Registered” is displayed.
[Notes concerning use of “Update” and
“Add New Feature”]
• Do not turn off the power until updating or upgrading is
completed.
• Even with a broadband connection to the Internet,
approximately 20 minutes is required for the updating/
upgrading procedure to be completed.
• Once updating/upgrade starts, normal operations on this unit
cannot be performed until updating/upgrading is completed.
• Furthermore, updating/upgrading the firmware may reset the
backup data for the parameters, etc. set for this unit.
• If the update or upgrade fails, remove and re-insert the power
cord. “Update Retry” appears on the display and update
restarts from the point at which update failed. If the error
continues despite this, check the network environment.
• Information regarding the “Update” function and “Add New
Feature” will be announced on the Marantz web site each
time related plans are defined.
• When usable new firmware is released with “Update” or
“Add New Feature”, a notification message is displayed on
the menu screen. When you do not want to be notified, set
“Update” (
“Off”.
Preparation
Operation
Information
Preparation
